Interactive Laboratory Engine

Aquarium CO2 ppm Calculator (pH & KH)

Estimate dissolved CO2 in ppm from pH, KH and temperature, with the formulas, example values and accuracy limits.

Laboratory Console Engine // SYS.2.5
ONLINE
Calibration Controls
3 Parameters
dKH
0.1 dKH 20 dKH

Measured KH from liquid test kit. If entering ppm CaCO3, divide by 17.848 first.

5 8.5

Calibrated digital pH meter or high-resolution test kit reading.

ยฐC
10 ยฐC 30 ยฐC

Used to calculate carbonic acid first dissociation constant (pK1) via Harned & Davis (1943).

Diagnostic Telemetry
Console Standby

Awaiting Parameter Calibration

Adjust parameters in the left console to initiate real-time telemetry and biological safety verification.

What is my CO2 level? Enter pH and KH to estimate dissolved CO2 in ppm. The result is valid only when carbonate is the only buffer in the water. Use it with a drop checker.

Calculate CO2

Enter KH in dKH (or ppm as CaCO3), pH, and water temperature. Set your photoperiod and injection window using the light duration calculator. The tool shows two estimates and a safety note. Test pH and KH on the same day with calibrated kits. For how CO2, illumination, and nutrients interact in intensive setups, see the high-tech planted tank guide. If your tank has aquasoil, driftwood or pH buffers, treat the result as unreliable.

How the calculation works

CO2 (mg/L, ppm) comes from the carbonic-acid equilibrium: CO2 = 15.7 x KH x 10^(pK1 - pH), where KH is in dKH and 15.7 = 0.3567 meq/L per dKH x 44.01 g/mol. The apparent pK1 is 6.35 at 25 C (LSBU). The common hobby chart uses a simpler form, CO2 = 3 x KH x 10^(7 - pH). This tool shows both.

TemperaturepK1 (apparent)Coefficient on KH x 10^(7-pH)
10 C6.464.53
15 C6.424.13
20 C6.383.77
25 C6.353.51
30 C6.333.36

The chart coefficient 3 is below the equilibrium coefficient at all these temperatures, by about 12% at 30 C and 26% at 20 C. The pK1 values come from a textbook table quoted on UKAPS. Results ignore ionic strength, which changes the apparent constant (Putnam and Roos).

Read carbon dioxide (CO2) for the chemistry and the CO2 injection guide for equipment.

Example values

Reading KH 4 dKH at pH 6.6 gives 30 ppm by the chart, and about 35 ppm by equilibrium at 25 C. A 4 dKH drop-checker solution turns green near that pH.

Example grid for KH 4 dKH
pH (KH 4 dKH)Chart-style estimate (ppm)Equilibrium estimate, 25 C (ppm)
7.289
71214
6.81922
6.63035
6.44856
6.27689

To reach a target, read the pH you need at your KH:

pH that the chart equates with a target CO2 (chart-style, x3)
KH (dKH)pH for 15 ppmpH for 20 ppmpH for 30 ppm
26.66.486.3
36.786.656.48
46.96.786.6
67.086.956.78
87.27.086.9

Accuracy limits

Treat the output as a rough guide, not a measurement. Photosynthetic carbon demand depends on potential plant growth rates and lighting; consult planted tank lighting and PAR before adjusting injection targets.

SituationEffect on the resultSource
Phosphate buffers, fertiliser, commercial pH buffersChart invalidAquarium Science
Aquasoil, driftwood, peat, tanninsExtra acids lower pH; CO2 is overstated2Hr Aquarist
KH below about 1 dKHKit resolution poor and other buffers dominateUKAPS
pH meter off by 0.1Result off by +26% or -21%Arithmetic: 10^0.1 and 10^-0.1
KH reading off by 0.5 dKH at KH 4Result off by 12.5%Arithmetic
Tap water just addedMay hold extra or too little CO2 for hoursAquarium Science

If a limit applies, trust a drop checker and the behaviour of your fish. Warning signs include gasping and sluggishness; see fish gasping at the surface.

FAQ

The questions below are answered in the FAQ section rendered under this article.

Calculator References

Chart-style vs equilibrium CO2 estimate

โ† Scroll horizontally to inspect full matrix โ†’
ItemChart-style (x3)Equilibrium (pK1)
Formula3 x KH x 10^(7-pH)KH x 0.3567 x 44.01 x 10^(pK1-pH)
Coefficient at 25 C3.003.51
KH 4, pH 6.630 ppm35 ppm
UseCompare with charts and drop-checker adviceSafer basis for fish limits

Frequently Asked Questions

How do I calculate CO2 from pH and KH?

Use CO2 = 3 x KH x 10^(7 - pH) for the hobby chart, where KH is in dKH. For KH 4 and pH 6.6 this gives 30 ppm. The equilibrium form uses a coefficient of about 3.5 at 25 C, so it gives roughly 35 ppm.

Why are there two results?

The chart form is the version most guides and drop-checker advice use. The equilibrium form comes from the carbonic-acid constant and temperature. Plan fish safety around the higher number.

Is the calculator accurate with driftwood or aquasoil?

No. Tannins, humic acids and phosphate buffers lower pH without adding CO2, so the result is overstated. Use a drop checker instead.

What if my KH is below 1 dKH?

The estimate is unreliable. Kit resolution is poor and other buffers dominate. Raise KH slowly before relying on CO2 figures.

What CO2 ppm is safe?

No single value is safe for all species. A planted-tank reference gives 10-25 ppm as desirable and says over 30 ppm can harm fish. Aquaculture sources say below 10 mg/L is well tolerated. Raise slowly and watch the fish.

Can I convert KH in ppm?

Yes. Divide ppm as CaCO3 by 17.848 to get dKH. For example 71 ppm is 4 dKH.