Water Chemistry Parameter

Carbon Dioxide (CO2)

Written by The Aquarium Calculators Editorial Team Updated on
CO2 (aq); CO2 + H2O <=> H+ + HCO3- (apparent pK1 6.35 at 25 C) โ€ข Type: Dissolved gas / weak acid system โ€ข Aliases: CO2, Carbon Dioxide, Dissolved CO2, Aquarium CO2, CO2 injection

How CO2 works in aquariums: ppm targets, the pH-KH relationship, how to measure it and warning signs in fish. Practical guidance for planted tanks.

Toxicity Risk
Moderate at high c...
Safe Target Range
2โ€“30 ppm
Detection Protocol
Colorimetric Probe
Biological State
Equilibrium Buffer

Molecular Dynamics & Toxicity Thresholds

โš ๏ธ Pathology & Physiological Impact

CO2 is part of every tank. Injection can raise it to levels that stress or kill fish. Sources give different limits: below 10 mg/L well tolerated in aquaculture, over 20 ppm 'bad' in a transport table, and over 30 ppm potentially harmful in a planted-tank reference. Invertebrates are reported to react first.

Equilibrium Modifiers & Influences:
โšก CO2 injection โšก Surface agitation and aeration โšก Fish and bacterial respiration โšก Decomposing soil and organic matter โšก Temperature โšก Carbonate rock (indirectly via KH)

Common Accumulation Sources in Aquariums

โ€ข Pressurised CO2 cylinders
โ€ข DIY yeast fermentation
โ€ข Fish respiration
โ€ข Decomposing organic matter and soil
โ€ข Source tap water before degassing

Reaction Network & Bio-Chemical Synergy

๐Ÿ”„
pH affects

More dissolved CO2 lowers pH at a given KH.

๐Ÿ”„
KH relatedTo

pH, KH and CO2 are linked. With carbonate-only buffering, two values give the third.

๐Ÿ”„
๐Ÿ”„
๐Ÿ”„

What CO2 Does in a Tank

Carbon dioxide (CO2) dissolves in water, forms a weak acid, and lowers pH. Every tank holds some. Without injection, open water settles near 2-3 ppm at equilibrium with the air (Aquarium Science), and fresh tap water can start higher or lower before it settles. Tanks operating without pressurized gas rely on atmospheric exchange, substrate breakdown, and livestock respiration, as detailed in our guide to the low-tech planted tank.

CO2 and Plants

Dissolved CO2 is the main carbon source for most aquarium plants. High-light planted tanks inject CO2 to raise it from 2-3 ppm to a target of 15-30 ppm. However, higher irradiance increases carbon uptake only when photosynthetic growth is not constrained by other limiting nutrients; review our guide to planted tank lighting and PAR before increasing injection rates. Aquarium Science gives 10-25 ppm as a desirable range and says 30 ppm is the common high-tech target (15.6). Low-tech and soil-based tanks get a modest amount from decomposing soil and fish respiration, without injection. See the CO2 injection guide and the bubble-per-second guide for equipment. Plant metabolism relies on the complementary roles of CO2, light and dissolved nutrients: when lighting and carbon rise, balanced liquid fertilizer dosing is essential to prevent nutrient exhaustion.

CO2 and Fish

More CO2 is not always better. Sources give different limits, and none is a guarantee:

  • Aquarium Science: over 30 ppm can harm fish; low-stocked tanks may tolerate up to 40 ppm.
  • Fish veterinarians: below 10 mg/L is well tolerated in aquaculture, with species differences (Fish Vet Group).
  • A University of Florida extension sheet on fish transport rates CO2 above 20 ppm as bad (UF/IFAS EDIS, archival).
  • Retailer guides report that invertebrates tend to show stress before fish (Light Fish).

Treat 30 ppm as an upper working target for planted tanks, not a safe limit for every species. Start low, increase slowly, and watch the fish.

The pH, KH and CO2 Relationship

CO2 + H2O reacts to give H+ and bicarbonate (HCO3-). With a fixed amount of bicarbonate (KH), more CO2 means lower pH. The equilibrium constant gives:

CO2 (mg/L) = 15.7 x KH (dKH) x 10^(pK1 - pH), with pK1 = 6.35 at 25 C (LSBU). The number 15.7 comes from 0.3567 meq/L per dKH times 44.01 g/mol.

Hobby charts use a simpler form: CO2 = 3 x KH x 10^(7 - pH). For KH 4 it gives 12 ppm at pH 7.0, 19 at 6.8, 30 at 6.6 and 48 at 6.4. We verified those four values. We also found that the chart's coefficient 3 is lower than the equilibrium coefficient, which is 3.51 at 25 C.

โ† Scroll horizontally to inspect full matrix โ†’
pH (KH 4 dKH)Chart-style estimate (3 x KH x 10^(7-pH)), ppmEquilibrium estimate at 25 C, ppmDifference
7.289+17%
71214+17%
6.81922+17%
6.63035+17%
6.44856+17%
6.27689+17%

The coefficient depends on temperature, because pK1 changes with it (values from a textbook table quoted on UKAPS):

โ† Scroll horizontally to inspect full matrix โ†’
Water temperaturepK1 (apparent)Coefficient on KH x 10^(7-pH)vs chart coefficient 3
20 C6.383.77+26%
25 C6.353.51+17%
30 C6.333.36+12%

So a chart reading of 30 ppm may correspond to roughly 33-38 ppm at equilibrium in water at 20-30 C, if bicarbonate were the only buffer. The chart is still useful because drop-checker colour guidance and most hobby advice are based on it. Keep both numbers in mind, and plan fish safety around the higher one.

Chart-style estimates for common KH values (ppm CO2):

โ† Scroll horizontally to inspect full matrix โ†’
KH (dKH) / pH7.276.86.66.46.2
24610152438
36914233657
481219304876
61118294572114
81524386096151

Three practical points from the chemistry:

  • KH does not set the CO2 level. If you change KH, pH moves but CO2 stays the same. If you change CO2, pH moves (Aquarium Science).
  • For a given CO2 increase, the pH drop does not depend on KH (for KH of 1 dKH or more). A drop of 1.0 pH unit always means 10 times the starting CO2. If the degassed baseline is about 3 ppm, a 1.0 drop gives roughly 30 ppm. This "pH drop" method needs no KH value (UKAPS; 2Hr Aquarist).
  • Calcareous rock can mislead pH controllers. Extra CO2 dissolves carbonate rock, KH and pH rise, and a controller may add even more CO2 (Aquarium Science).

How to Measure CO2

Drop Checkers

A drop checker is a small glass bulb with a pH indicator (bromothymol blue) in a reference solution, usually 4 dKH, separated from tank water by an air gap. CO2 diffuses in and changes the colour. Blue means low, green means near target, and yellow means too high. A 4 dKH reference solution turns green at about the pH the chart equates with 30 ppm: pH = 7 - log10(30 / (3 x 4)) = 6.6. Replace the solution on the manufacturer's schedule (a retailer guide says every 3-4 weeks).

Limits: drop checkers respond slowly and average over roughly three hours (Aquarium Science), so they miss short spikes. Because the reference solution is isolated from tank water, tannins and aquasoil acids do not affect the colour (Gensou).

pH-KH Calculation and Its Limits

You can calculate CO2 from pH and KH with the CO2 ppm calculator. The result is only valid when carbonate is the only buffer. These break it:

  • Phosphates, including some plant fertilisers, fish food, and commercial pH buffers (Aquarium Science).
  • Humic and fulvic acids from aquasoil, tannins from driftwood, peat, or botanical tannins in fish tanks (2Hr Aquarist; Gensou).
  • KH below about 1 dKH, where test resolution is poor and other buffers dominate (UKAPS).

Measurement error also adds up. A pH error of 0.1 changes the estimate by about +26% or -21%. A KH error of 0.5 dKH at KH 4 changes it by 12.5%. Calibrate your pH meter and take both readings the same day. If your tank has aquasoil or driftwood, trust the drop checker over the calculation.

Warning Signs in Fish

Retailer guides list these signs of too much CO2 (2Hr Aquarist; Light Fish): lowered activity, hiding, laboured breathing, delayed response to food, erratic swimming, and hovering or gasping at the surface. A large pH drop and a yellow drop checker support the diagnosis. Shrimp and snails may react first.

If you see these signs: stop the CO2, raise surface agitation or add an air stone, and do a water change. Gasping also has other causes, including low oxygen and ammonia, so check those too (see fish gasping at the surface). Fish stressed by CO2 can show secondary problems later, so keep watching for a few days.

To prevent problems, start with a low bubble rate, raise it in small steps over days, and keep the drop checker in view. Check that the gas stops when the solenoid closes.

CO2 Methods Compared

The table shows the main ways to add CO2, with the sources' own limits and disagreements.

โ† Scroll horizontally to inspect full matrix โ†’
MethodHow it worksControlReported prosReported cons and safetySource
Pressurised cylinderRegulator, solenoid and diffuser or reactor feed CO2 gasPrecise; solenoid can switch off at nightStable and controllable once set up (UKAPS poster)Failures can overdose a tank; Aquarium Science says expect occasional fish losses and advises aeration at night with moderate stockingUKAPS; Aquarium Science; Aquarium Science
DIY yeastYeast and sugar fermentation in a bottlePoor; output declines over days and cannot be timedVery low costUnstable levels and frequent refills; never close the outlet (pressure); Aquarium Science does not recommend itUKAPS; Aquarium Science
Passive bottle or jar diffuserSmall CO2 supply through a bottle or jarLowSimple for small low-tech tanksWill not feed a high-light tank; suits tanks under about 20 gallons per the authorAquarium Science
Liquid carbon (glutaraldehyde)Dosed liquid disinfectant sold as 'liquid CO2'Dose onlyAlgae suppression; simpleJBL calculates at most about 1.76 mg/L CO2 from 1 mL of a 4 percent solution per 50 L (about 0.7 realistic); one forum view says plants process it internally; some plants (e.g. Riccia) can degenerateJBL; Aquarium Science; UKAPS

Related Guides and Tools

CO2 methods compared

โ† Scroll horizontally to inspect full matrix โ†’
MethodHow it worksControlReported prosReported cons and safetySource
Pressurised cylinderRegulator, solenoid and diffuser feed CO2 gasPrecise; can switch off at nightStable and controllable once set upEquipment failure can overdose a tankUKAPS; Aquarium Science 15.6.3
DIY yeastYeast and sugar fermentation in a bottlePoor; declines over daysVery low costUnstable levels; frequent refills; never block the outletUKAPS; Aquarium Science 15.6
Passive bottle or jar diffuserSmall CO2 supply through a bottle or jarLowSimple for small low-tech tanksWill not feed a high-light tankAquarium Science 15.6.1
Liquid carbon (glutaraldehyde)Dosed liquid disinfectant sold as 'liquid CO2'Dose onlyAlgae suppressionNegligible CO2 per JBL and Aquarium Science; a contrasting forum view; some plants are sensitiveJBL; Aquarium Science 15.6.5; UKAPS

Frequently Asked Questions

How much CO2 should a planted aquarium have?

Sources give 10-25 ppm as a desirable range and 30 ppm as the common high-tech target. Aquarium Science says over 30 ppm can harm fish. Start low and raise slowly while you watch the fish. Species differ, and invertebrates often react first.

Is 30 ppm CO2 safe for fish?

Not for every species. Aquarium Science treats 30 ppm as the upper end for fish, and aquaculture sources describe levels below 10 mg/L as well tolerated. A chart reading of 30 ppm may be higher at equilibrium. Judge by fish behaviour and a drop checker, not by one number.

Can I trust the pH-KH chart if I have driftwood or aquasoil?

No. Chart values assume that carbonic acid is the only acid. Tannins, humic acids, phosphates and pH buffers lower pH without adding CO2, so the chart overstates CO2. Use a drop checker or the pH-drop method instead.

What is the pH-drop method?

Measure pH of degassed water before the lights and CO2 start, then measure again when CO2 is at its peak. A drop of 1.0 pH unit means about 10 times the starting CO2, roughly 30 ppm if the start was 3 ppm. It does not need a KH value but still needs a calibrated pH meter and carbonate-only buffering.

Does changing KH change CO2?

No. KH sets how pH responds, but only adding or removing CO2 changes the CO2 level. If you raise KH with the same CO2 supply, pH goes up and CO2 stays the same.

How accurate is a drop checker?

It shows a rough, delayed average, about three hours according to Aquarium Science, and is not a precision instrument. It is less affected by tannins and aquasoil acids than the chart because its reference solution is separated from tank water.

Why are my fish gasping after the lights come on?

CO2 may be too high, but low oxygen or ammonia can cause the same behaviour. Turn off the CO2, increase surface agitation, and check the drop checker, ammonia and nitrite. Retailer guides advise a water change or rapid aeration.